Shellab SMO10HP-2 Uživatelský manuál

HORIZONTAL AIR FLOW OVEN SMO10HP-2 Previously designated as: HF10-2 INSTALLATION AND OPERATIONAL MANUAL Revised 11/2013 486158

10 1. Push the PGM Button once and then navigate using the Up and Down Arrows until you reach “CONF” in the bottom display. 2. After you reach “CO

11 EXAMPLE PROGRAM Let’s say you want to have the oven to ramp up to 100°C in 30 minutes and control for 1 hour at 100°C. Then you want to ramp u

12 at -2 to match the process value to the independent thermometer. To navigate the control to the Offset Calibration mode, push the PGM

13 MAINTENANCE 7.1 Cleaning: The unit chamber should be cleaned and disinfected on a regular basis. Remove shelving & shelving

14 TROUBLESHOOTING TEMPERATURE Temperature too high 1/ controller set too high-see your Watlow users manual 2/ controller failed on – call Customer

15 Unit will heat up at all 1/ verify that controller is asking for heat by looking for controller light – if controller light is not on, there is a

16 Motor doesn't move 1/ if shaft spins freely: check connections to motor and check voltage to motor 2/ if shaft rubs or is frozen, relieve b

17 PARTS LIST Units are 220 Volt. Description Part No. Blower Motor 4880548 Convenience Outlet 6100531 Cooling Fan X1000748 Connector Sub-D 9 Pin 1650

18 UNIT SPECIFICATIONS These units are 220 VAC. See the individual data plate of the unit for specific ratings. Weight Shipping Net SMO10HP-2 (HF10-

19 WIRE DIAGRAM

2 TABLE OF CONTENTS SECTION 1.0 RECEIVING AND INSPECTION SECTION 2.0 GRAPHIC SYMBOLS SECTION 3.0 INSTALLATION SECTION 4.0 CONTROL OVERVIEW SECTION

20 SHELDON MANUFACTURING, INC. LIMITED WARRANTY (Parts only, exclusive of labor) Sheldon Manufacturing, Inc., (“Manufacturer”) warrants for the ori

3 Section RECEIVING AND INSPECTION Your satisfaction and safety require a complete understanding of this unit. Read the instructions thoroughly and be

4 1.4 Verify that all of the equipment indicated on the packing slip is included with the unit. Carefully check all packaging before discarding. Th

5 GRAPHIC SYMBOLS Your oven has been provided with a display of graphic symbols which is designed to help in identifying the use an

6 INSTALLATION Local city, county or other ordinances may govern the use of this equipment. If you have any questions about local requirements, pleas

7 CONTROL PANEL OVERVIEW 4.1 Power Switch: The main power I/O (on/off) switch controls all power to the unit and must be in the I/ON positi

8 PRECAUTIONS 5.1 The bottom surface of the chamber should not be used as a work surface. 5.2 This unit has been designed with a dampere

9 OPERATION All control functions are covered in the Jumo Manual. This is a simplified version. Unit must be plugged into correct rating